Case Studies

(c) SIGMA Engineering GmbH

Runner balancing: everything counts (c) SIGMA Engineering GmbH

Runner balancing: everything counts

In the very early stage of part development, when not much more than the part properties is ... read more

Injection Molding Simulation improves the Results of Crash Simulation (c) SIGMA Engineering GmbH

Injection Molding Simulation improves the Results of Crash Simulation

Typical failure prediction for mechanically loaded components is unable to consider fiber ... read more

Improving the reliability of structural simulation by considering process-induced fiber orientation (c) SIGMA Engineering GmbH

Improving the reliability of structural simulation by considering process-induced fiber orientation

In order to improve the mechanical properties (especially the stiffness) of a part, glass ... read more

SIGMASOFT – Multicomponent Mode – More than just the sum of all things (c) SIGMA Engineering GmbH

SIGMASOFT® – Multicomponent Mode – More than just the sum of all things

The spirit of achieving the most with the least amount of steps necessary – efficiency – has ... read more

Over-molding sensitive components: how to avoid component damage (c) SIGMA Engineering GmbH

Over-molding sensitive components: how to avoid component damage

The application in the videos shows an insert that needed to be over-molded by a polymer. ... read more

1
2
3

This site uses cookies to offer you a better browsing experience Privacy policy

✖